Choose your AP amplifier
Match the reference to the channel layout you need. The option currently named Standard is the monoblock model for a subwoofer.
| Option | Part number | Configuration |
|---|---|---|
| Standard | 010-03428-00 | Monoblock / subwoofer |
| 4-Channel | 010-03429-00 | 4 channels |
| 6-Channel | 010-03430-00 | 6 channels |
| 4-Channel + Bluetooth | 010-03431-00 | 4 channels with Bluetooth |
Check your system: tell us your stereo model, speaker/subwoofer models, impedance and intended wiring. Channel count alone is not enough to confirm a suitable installation.
Box contents: the selected AP amplifier, four mounting screws and documentation.
Preparation and carrier transit are separate. Check the dispatch estimate above and our shipping options and transit times.
With these tough and ultracompact amplifiers, you can enjoy every note from every part of your boat.
Features
- Efficient CLASS-D design
- Available in monoblock, 4 channel and STAGGERED-POWER 6 channel
- BUILT-IN Lcd display for manual control
- Ignition protected and IP67-RATED (excluding cables)
- Easy tune feature
- 300-WATT Monoblock Amplifier: This monoblock amplifier is specifically designed to power a subwoofer.
- 300-WATT 4 Channel Amplifier: This 4 channel amplifier can power up to a maximum of four pairs of speakers or two pairs of speakers and one subwoofer.
- 600-WATT 6 Channel Amplifier: This staggered-power 6 channel amplifier can power up to a maximum of six pairs of speakers or four pairs of speakers and one subwoofer.
- Easy Tune Feature: For additional optimization, pair with a Fusion® stereo with built-in DSP, and download the Fusion® Audio app for selectable profiles. This enables the Easy Tune feature, which streamlines amplifier setup to ensure superior sound quality and system protection.
- CLASS-D Amplifier Technology: The highly efficient Class-D design provides lower battery drain with a higher output than Class-AB amplifiers. This delivers increased power to the connected speakers/subwoofers for an enhanced level of audio performance.
In the box
- JL Audio AP amplifier (based on your selection)
- Four mounting screws
- Documentation
Specifications
| Channels | Monoblock/4/6 Channel |
|---|---|
| Physical dimensions (Height) | 1.86″ (47 mm) |
| Physical dimensions (Width) | Monoblock/4 Channel: 10.43″ (265 mm) 6 Channel: 11.81″ (300 mm) |
| Physical dimensions (Depth) | Monoblock/4 Channel: 4.90″ (125 mm) 6 Channel: 5.90″ (150 mm) |
| Operating voltage | 9-16 Vdc |
| Water and dust rating | IP67 |
| Operating temperature range | 4° to 149° F (-20° to 65° c) |
| Warranty | 3 years |
| Amplifier class | Class D |
| Rated continuous (RMS) power (14.4 V input @ 4 Ohm <1% THD) | Monoblock: 200 W x 1 4-Channel: 50 W x 4/150 W x 2 (Bridged) 6-Channel: Channels 1-4: 50 W x 4/150 W x 2 (Bridged); Channels 5-6: 100 W x 2/300 x 1 (Bridged) |
| Rated continuous (RMS) power (14.4 V input @ 2 Ohm <1% THD) | Monoblock: 300 W X 1 4 Channel: 75 W X 4 6-Channel: Channels 1-4: 75 W X 4; Channels 5-6: 150 W X 2 |
| Signal-to-Noise Ratio, referred to 1 W (A-weighted, 20 Hz – 20 kHz noise bandwidth): Analog Inputs | >70 dB |
| Frequency response (+0, -1dB) | Monoblock: 10 Hz-500 Hz 4/6-Channel: 20 Hz-20 khz |
| Input sensitivity @ RCA inputs | Switchable from 200 mV-2 V RMS (Low) to 800 mV-8 V RMS (High) |
| Input impedance | 11 kΩ (High) 20 kΩ (Low) |
| Current consumption (Standby) | <1mA |
| Current consumption (Idle) | Monoblock/4-Channel: 700-750mA 6 Channel: 1000mA-1500mA |
| Fuse rating | Monoblock/4 Channel: 35A 6 Channel: 70A |
| Recommended fuse type(s) | AFS, AGU or MaxiFuse™ |
| Min. copper power/Ground wire gauge | 4 AWG wire |
| Protection circuits | Input under/over voltage Over temperature Output short circuit |
| High-pass/Low-pass full range filter | yes (user selectable) |
| Filter mode(s): Channels 1 & 2 | Monoblock: Low-pass 4/6-Channel: Off, Low-pass or High-pass |
| Filter Slope(s): Channels 1 & 2 | 12 dB/octave |
| Filter frequency range: Channels 1 & 2 | 20 Hz-500 Hz |
| Filter mode(s): Channels 3 & 4 | 4/6-Channel: Off, Low-pass or High-pass |
| Filter Slope(s): Channels 3 & 4 | 4/6-Channel: 12 dB/octave |
| Filter frequency range: Channels 3 & 4 | 4/6-Channel: 20-500 Hz |
| Filter mode(s): Channels 5 & 6 | 6-Channel: Off, Low-pass or High-pass |
| Filter Slope(s): Channels 5 & 6 | 6-Channel: 12 dB/octave |
| Filter frequency range: Channels 5 & 6 | 6-Channel: 20 Hz-500 Hz |
| HP variable crossover frequency range | 4/6 Channel: 12 dB/octave |
| LP variable crossover frequency range | Monoblock/4/6 Channel: 20-500Hz |
| Infrasonic filter: Subwoofer Channel | Monoblock: 20 Hz-50 Hz, defeatable 6-Channel: 20 Hz-50 Hz, defeatable (Channels 5-6 only) |
| Output polarity switch | Monoblock: yes |